How To: Ink Charge (SG400/SG800)

  • Updated

If for troubleshooting purposes you wish to flush ink through the printer, you may do this by performing an initial ink charge. Please bear in mind that we recommend this be performed only once in a 24 hour period and that it will use up to 25% ink.

  1. Enter the SP mode. (Press the up and down keys at the same time for 7 seconds, then press the #key).
  2. Select "Engine Maint."> [#Enter].
    SP No.
  3. Enter "3008002"> [#Enter].RST:INIT CNT:A
  4. Press [#Enter].
  5. Press [#Enter].
    Press [#Enter]
  6. Exit the SP mode.
  7. Switch the machine off.
  8. Replace the ink cartridges if required
  9. Switch the machine on, the printer will start the initial ink fill process.